top of page
GpO BOX logo .png

OSC

£250.00

GpO BOX OSC

The GPO BOX OSC is a 6-output, fully user-programmable OSC relay interface designed to trigger contact closures over the network. Built for show control, installations, and live events, it enables network-based control of non-networked hardware using simple, reliable contact closures.

Each of the 3 male XLR connectors carries two independently addressable relays, providing six outputs in total. The polarity and duration of each closure can be configured via a built-in web interface, allowing you to fine-tune the response to match your system’s requirements. Whether you're firing cue lights, activating relays, or bridging OSC into legacy control systems, the GPO BOX OSC gives you powerful, flexible control with minimal setup.

 

  • Power via POE or USB

  • 6 relay outputs via 3 male XLR sockets

  • User-configurable polarity and pulse duration

  • Receives OSC from QLab, EOS, Isadora, and other controllers

  • Local Test Button for each output

  • Ideal for cue lights, remote triggering, and show control integration

     

The GPO BOX OSC adds precise, network-based control to systems that rely on traditional contact closures—no custom protocols, no complicated wiring, just reliable performance on a standard network.

Resources

GpO BOX OSC manual 

More Info

​Each of the 3 XLR sockets on the rear of the GpO BOX OSC is connected to 2 relays allowing for simple networked control of up to 6 devices.  
 ​
When shipped the GpO BOX OSC has a default IP of 192.168.0.102 and a subnet of 255.255.0.0. To edit the settings of your unit, connect it to a computer and type its IP in to a web browser. Once you have reached the settings page you can edit the network settings, the Pulse Time and the startup state of each relay allowing for normally closed, and normally open operation. You will also find an OSC control table listing all available commands. the Test button on the front of the GPO BOX OSC can be used to pulse all relays at once. 

Dimensions: 160mm x 110mm x 40 mm

Firmware Update 

to update your firmware use the link above in the resources section to download the updater. Run thus updater utility with Terminal in MacOS with your GpiO BOX OSC in setup mode. enter your IP address and hit update.

For more information, download the instruction document, or drop us a line using the contact page.

GPO BOX WEB INTERFACE
IMG_5283_edited.jpg
IMG_5284_edited.jpg
bottom of page